2 replies to this topic

[dynotimeonly]

Mike Ingram built 604 GM crate motor. RUSH sealed, (Green Crate USA). Race ready to install.

* MSD dist w/ MOROSO plug wires
* NEW Pro-cam fuel pump fuel pump
* Water lines installed
* KRC Serpentine pulleys
* New set of NGK plugs
* New set of bee-hive springs.
* Set of header gaskets


$5900.  ( Will consider a trade on an all alum 420ci+ motor).


** Fresh INGRAM billet carb & 1" angled spacer, $1000 (Phil Shaw did the freshen)
** BEYEA nickle coated Rocket header's. $350
** Brand new BRINN flywheel w/ HTD drive. $225
** Used BERT flywheel non-HTD. $75
** FRESH Brinn tranny & Bellhousing. $1250.
** Like new 35-1/2"long, 2" OD "crate" carbon fiber driveshaft w/ yoke. $500


Contact me for pic's & info. THANKS

Edited by dynotimeonly, 03 March 2019 - 07:47 AM.

[rjx23]

Hello there,

 

I have an all aluminum 430 Ford (older Cornett Motor) that I would be interested in trading for your crate motor.  The motor does need a head gasket replaced as it went bad the very last time on the track last year.  It was not run after that.  It had been just freshened up before that by Edge Racing Engines.  Has newer cam from Cornett in it, Neil Brodix heads with new valve springs as well.  I have all dry sump lines, 5-stage pump, Bert Bellhousing and Peterson Oil Tank, Radiator, Carb (Demon redone by Edge Racing Engines), carb spacer, and headers.  Let me know if interested.

 

I just purchased a Hendren 604 but I would be interested in this if you are.

[rjx23]

I forgot to add, I can get you pics as well.  My engine also has the MSD distributor that was in it and a brand new MSD distributor as well.  Again, this engine is complete.